Description
This part of the SZNS SANS 10087 gives requirements for the design, construction, inspection, fittings and the filling ratio of pressure vessels (mounted onto vehicles or rail wagons), including ISO containers and skid tanks, used in the transportation of liquefied petroleum gas (LPG), the design of vehicles and ancillary equipment, and operating practice.
TABLE OF CONTENTS
| Content | Page |
| 1 Scope | 1 |
| 2 Normative references | 1 |
| 3 Definitions | 2 |
| 4 Design and construction requirements for road vehicles | 3 |
| 5 Design, construction and testing of the pressure vessels for road and rail transport | 4 |
| 6 Filling by volume | 8 |
| 7 Vehicles | 8 |
| 8 Ancillary equipment | 10 |
| 9 Driver instructions and training | 12 |
| 10 Loading and decanting of LPG bulk delivery vehicles | 12 |
| 11 Parking and garaging of vehicles used to carry LPG | 13 |
| 12 Decanting of LPG from rail tank cars | 13 |
| Annex A (informative) Typical rail tank car discharge procedure | 14 |
| Annex B (informative) Check sheet for the road transport of containers from 0,5 L to 113 L (water capacity) by truck or light delivery vehicle of gross vehicle mass less than 3 501 kg | 17 |
| Annex C (informative) Check sheet for the road transport of containersfrom0,5 L to 113 L by truck of gross vehicle mass exceeding 3 500 kg | 20 |
| Annex D (informative) Check sheet for the transport of LPG bulk delivery by road vehicles | 23 |
| Annex E (informative) Check sheet for the transport of LPG bulk delivery by rail | 26 |
| Annex F (informative) Rate of discharge of pressure relief devices | 28 |
| Bibliography | 30 |